How to measure with it
- Calibrate once. Hold a bank card (or a coin) on the screen and drag the yellow dot until the dashed outline matches it. Every bank, ID and loyalty card is the same size, 85.6 by 53.98 mm, so the ruler learns exactly how big your screen's pixels are. It remembers this on this device.
- Put your object on the screen, touching the left (or top) red jaw. Press Start at 0 to move that jaw to the end of the ruler.
- Drag the other jaw to the far end of the object, or just tap there. The size shows in big numbers, with the other units underneath.
Why most online rulers are the wrong size
A browser does not know how big your screen really is. It draws 96 "CSS pixels" to an inch, but on a real phone or laptop that can be off by a third or more. That is why a ruler that is not calibrated can show 1 inch as 0.8 inch. Matching a card you already own fixes this in a few seconds, without knowing your screen size.
If you have no card, pick a coin, or type your screen size in inches (it is written in your device's specs). The card is the most exact, because it is the largest.
How long is 1 cm?
One centimetre is 10 millimetres, about the width of a fingernail on a small finger, or a little under 4/10 of an inch. Press Show a size and type 1 cm to see it life size on your screen.
| cm | mm | inches |
|---|---|---|
| 0.5 cm | 5 mm | 0.20 in |
| 1 cm | 10 mm | 0.39 in |
| 2 cm | 20 mm | 0.79 in |
| 2.5 cm | 25 mm | 0.98 in |
| 3 cm | 30 mm | 1.18 in |
| 5 cm | 50 mm | 1.97 in |
| 10 cm | 100 mm | 3.94 in |
| 15 cm | 150 mm | 5.91 in |
| 20 cm | 200 mm | 7.87 in |
| 30 cm | 300 mm | 11.81 in |
Questions
How many cm are in an inch?
2.54 cm.
How long is a 30 cm ruler in inches?
About 11.8 inches.
How accurate is an online ruler?
After calibrating with a card it is usually within about half a millimetre on a laptop and better on a phone, because phone screens have more pixels per millimetre. Without calibration it can be off by a lot.
Can I measure something longer than my screen?
Measure up to the screen edge, put a small mark on the object, slide it along and add the two readings. For long things a tape measure is quicker.